Lifting Solution Specialist

Grade 8 Alloy Lifting Chain

Home  Products  >  Chain and Sling Components  >  Grade 8 Alloy Chain

Grade 8 Lifting Chain
Grade 8 Alloy Chain
Grade 8 Lifting Chain
Grade 80 Lifting Chain
Grade 80 Chain for Sling

G-80 LASHING CHAIN

ITEM NO
CHAIN
SIZE
LINK DIMENSION
TEST
LOAD
BREAKING
LOAD Min.
WEIGHT
PER M
S(DIA.)
R(I.L)
F(I.W.)
MM
MM
MM
MM
KN
KN
KG
G8L0635
6
6
35
22
22
44
0.64
G8L0953
9
9
53
33
49
98
1.42
G8L1164
11
11
64
40
73.5
147
2.18
G8L1380
13
13
80
48
95
190
3.01

Definitions to European Standard EN 818-7

For the purposes of this Part of EN 818,the following definitions apply:
1. nominal size:  Nominal diameter of the round section steel wire or bar from which the chain is made.
2. material diameter: Diameter of the material in the chain link as measured.
3. weld diameter: Diameter at the weld as measured.
4. length dimensionally affected by welding: Length on either side of the center of the link, affected by welding.
5. pitch: Internal length of a link as measured.
6. manufacturing proof force(MPF) of chain: Force to which during manufacture the whole of the chain is subjected.
7. breaking force( BF): Maximum force which the chain withstands during the course of a static tensile test to destruction.
8. working load limit (WLL) of chain: Maximum mass which the chain hanging vertically is authorized to sustain in general lifting service.
9. total ultimate elongation (A): Total extension at the point of fracture of the chain expressed as a percentage of the internal length of the test sample.
10. processing: Any treatment of the chain subsequent to welding, for example, heat treatment, polishing or dimension calibration.
11. lot: Specified quantity from which test sample(s) is/are selected.
12. competent person: A designated person, suitably trained qualified by knowledge and practical experience, and with the necessary instructions to enable the required examination to be carried out.